Sewing Machine Lights
Typical Garment factories use
overhead fluorescent lighting at a
height of about two meters above the
sewing machine lines. These lights are
mandated by the factories act to ensure
good light and working conditions for
the operator. However, the cost of this
type of lighting is very high,
maintenance is high and they are still
inadequate because the actual job spot
where the light is required is not well
lit. Therefore, in addition to the
overhead lighting, most factories use a
portable lamp to light on the sewing
machine table. These table lamps are
cumbersome and use up even more energy
because they are incandescent. Heating
is also an issue and there is always a
danger of falling due to the fact that
it is not bolted on the machine table.
Our Sewing machine
LED light resolves all these issues. It
is designed to be simple to mount and
consumes only 0.2W of energy each!! Each
light produces over 810Lux of White
light that illuminates the specific job
area. The light is cold and unobtrusive.
Finally, with the use of these lights,
it may be possible to use general
lighting on a sewing machine line
instead of expensive tube lights.
Cold White Light
Between 810 - 1000
Lux measured at the job spot depending
on the type of sewing machine used.
Easy to mount -
magnetic mount just snaps on between the
needle shaft and saddle shaft.
Separate power supply
connects to motor pedal. Light comes on
when motor comes on. Can be also kept
switched on permanently.
Over 100,000 hours
Suitable for any type
of sewing machine
(Click on the
image to view more details)